SATWORK 3688 /3188 Receiver's System Menu

From left you find the System Menu screen captured, includes:

Channel

Channel Edit

edit channel setting of TV or Radio

INSTALLATION

here has most of the installation related settings that you need to verify or change.

ANTENNA INSTALLATION

Select the Satellite name you want from the list.

ANTENNA CONFIG

Use this screen when you are tuning the dish to get the signal, after that, scan the satellite to get the channels list.

you need to select the lnbf type and a working tp for tuning the signal.

lnbf : ku band Normal 10750, most of the lnbf use 10750 as the american standard.

or universal 10600 ex: ( If you have Universal LNBF such like 321-2 LNBF , then use Universal

LO - Low 9750 High 10600 ) model asc321-2.

TP(Transponder): use a working ku band Transponder frequency

C band Frequency is 4 digits, ex: 4444 , if you are using ku band dish to find the satellite, then don't use the c frequency, which is 4 digits Frequency.

Ku band frequency is 5 digits, ex 55555, use a good working transponder Frequency to tune your antenna. recommend you to use those as following:

SAT: Freq/Symbol/Pol

G3C: Freq: 11780 / 20760/H

T5: Freq: 11836

T5: Freq 12177/23000/V

AMC4: Freq11860/28130/H

the left screen shot is showing the red bars of both Level and Quality, it means satellite is locked. Do the Satellite Scan AFTER you completely the satellite locking.

locked the signal and ensure your picture quality,

No quality bar = No picture

Setup With H-H-Mount Motor SG-2100

enable the DiSEqC setting as MOTOR.

usually people save the east west limit to protect the motor, it is your option to save or not .

you will see the Motor function come out. use your remote control to move the dish East or West until the satellite locked. remember to save all data into the system database when exit or power down.

• Move motor by remote or manual press the motor direction button to store the limit.
• store east when dish at the end of east side
• store west limit when dish at the end of west side

NTSC vs PAL

If your screen is scrolling up and down, you can set the tv setting back to NTSC as follow:

press MENU, Right arrow 2 times, Down arrow 3 times, press Right or Left arrow to toggle the TV setting back to NTSC or AUTO.