BEC DBS-2000 / DBS-1000 Receiver's System Menu

From left you find the System Menu screen captured, includes:

Channel List

Channel Edit

edit channel setting of TV or Radio

Utility

Timer

Adjust your own time

Setup

here has most of the installation related settings that you need to verify or change.

CHANNEL SEARCH

the left screen shot is showing the red bars, it means satellite not locked. Do the channel search when you completely satellite locked.

you need to have the bar shown, it locked the signal and ensure your picture quality, must be over 50 and turn in yellow color.

No quality bar = No picture

Use this screen when you are tuning the dish to get the signal, after that, scan the satellite to get the channels list.

This is the screen you need, it turns to yellow, satellite is locked

(Your dish type should be Fixed. I am using HH-mount Motor, so the screen shot shown DiSEqC 1.2)

LNB PORT SETUP

Telstar5 is the default

This is the page that you need BEFORE setup the outside dish and aiming,

To Add/Change the Transponder frequency -- Hi-light the Frequency and press Select, then you can make any change.

Dish Type: Fixed ( no H-H mount installed )

1. Dish Setup

Your default Dish 1 should be this,( don't need to setup LNB index 2, since you only have one LNB )

standard C/Ku LNBF LO Freq is this

( If you have Universal LNBF such like 321-2 LNBF , then use Universal LO -

Low 9750

High 10600 )

Setup With H-H-Mount Motor SG-2100

Different Setting for you when you have H-H mount Drive Motor

From LNB Port Setup:

1.From the transponder setup: change your dish type from Fixed to DiSEqC 1.2

2.From DiSEqC1.2 setup:

• Move motor by remote or manual press the motor direction button to store the limit.
• store east when dish at the end of east side
• store west limit when dish at the end of west side
• select next

3. you will see the Motor function come out. use your remote control to move the dish East or West until the satellite locked( when you see the yellow bar shown)

4.select the Store SAT button to store the position of the satellite

5. at the screen, move the select satellite, press enter to to chose different satellite, for example Galaxy 4R

6.select Motor control, and move East until you get the yellow bar.

7. Store the position of Galaxy 4R, then at same screen, go to satellite to chose different satellite name.

8. do the same step like step 6.7.( you may have hard time to get the yellow bar, try chose different transponder Frequency,sb rate, pol, and move the motor to the direction of the select satellite )

9 . remember to save all data into the system database when exit or power down.

Satellites: List (Telstar 5)

LNB: Normal 5150MHz 10750Mhz